This guide will walk you through the process of getting two Fuchsia devices set up and synchronizing story state using the Ledger.
Follow the steps at in the top level docs to:
- Check out the source and build Fuchsia.
- Install it on two devices (or emulators).
- Connect the devices to the network.
Identify Test Machines
Each Fuchsia device has a unique node name based on its MAC address. It is of
power-nerd-saved-santa. You can list the nodes on your network with
> netls device glad-bats-hunk-lady (fe80::f64d:30ff:fe68:2620/6) device blurt-chip-sugar-wish (fe80::8eae:4cff:feee:4f40/6)
Running Commands On Test Machines
netruncmd <nodename> <command> command can be used to run commands on
remote machines. The output of the command is not shown. If you need to see
the output, use the
loglistener [<nodename>] command.
Ledger is a distributed storage system for Fuchsia. Stories use it to synchronize their state across multiple devices. Follow the steps in Ledger's User Guide to:
- Set up persistent storage. (optional)
- Verify the network is connected.
- Configure a Firebase instance.
- Setup sync on each device using
The systems boots up with three virtual consoles. Alt-F1 through Alt-F3 can be used to switch between virtual consoles.
The format of the Ledger as well as the format of the data each story syncs is
under rapid development and no effort is currently made towards forwards and
backwards compatibility. Because of this, after updating the Fuchsia code, it
is a good idea to wipe your remote and local data using
$ netruncmd <nodename> cloud_sync clean
Start A Story On One Device
basemgr to start a story on one device:
$ netruncmd <first-node-name> "basemgr --session_shell=dev_session_shell \ --session_shell_args=--root_module=example_todo_story"
loglistener <first-node-name> take note of the story ID from a line the
... DevSessionShell Starting story with id: IM7U9hBcCt
Open The Same Story On The Second Device.
The story can be started on the second device either through the system UI or by specifying the story ID.
System UI, aka Session Shell, aka Armadillo
Launch the system UI using
$ netruncmd <second-node-name> "basemgr"
Once the system UI starts, you should be able to see the story started in the step above. Click on that to open it.
By Story ID
With the story ID noted above from launch the story from a shell:
$ netruncmd <second-node-name> "basemgr \ --session_shell=dev_session_shell \ --session_shell_args=--story_id=<story_id>
Except as otherwise noted, the content of this page is licensed under the Creative Commons Attribution 4.0 License, and code samples are licensed under the Apache 2.0 License. For details, see the Google Developers Site Policies. Java is a registered trademark of Oracle and/or its affiliates.
Last updated 2019-12-10.