Zxdb is a console debugger for native code compiled with DWARF symbols (C, C++
and Rust). The frontend runs on the host computer and connects to the on-device
debug_agent. This document describes how to set up these processes.
Running the agent
debug_agent is run on the target device along with the port number that
it should listen to for incoming client connections. Typically this command
will be run from a console after ssh-ing in to the system:
run fuchsia-pkg://fuchsia.com/debug_agent#meta/debug_agent.cmx --port=2345
Connecting the client
zxdb client program is run on the host computer. It can be connected to
debug_agent via the interactive
connect debugger command or it can
automatically connect based on a command-line flag. Both IPv4 and IPv6
addresses are supported (see device discovery to find
the address). The port should match the port number passed to the agent.
zxdb -c "[f370::5051:ff:1e53:589a%qemu]:2345"
Connecting via a script
Scripts may want to automatically launch the agent and client automatically. The script should wait for the port to be open on the target system before launching the client. Automatic retry is not yet implemented in the client.
To clean up the debug agent gracefully when the client exits, pass the
--quit-agent-on-exit command-line flag to the client.
Specifying symbol paths
The debugger expects unstripped ELF files to be available on the local host
system. Symbols on the target are not used. The location where the local build
stores symbols must be passed to the
For more information on how to specify symbol paths, see set the symbol location